The feed roller and separation pad for the manual feed tray may need to be replaced. Replacing the drum unit and resetting the drum life counter sill see this error code removed. The drum unit needs to be replaced as it's reach the end of it's life cycle. This can become defective and will need to be replaced by an engineer if this is the case. Used to check the print density, the density sensor has developed a fault and can be resolved by switching the machine off and on.Īn issue has arisen with the density sensor shutter. Attempt switching the machine off and on to resolve the issue.
Used to write the information to be printed onto the drum surfaces, there has been a laser diode failure. Remove the unit and clean off any residue. To avoid deterioration of print quality, seek assistance from an engineer.ĭust or loose toner has been detected around the drum unit. The laser unit needs to be replaced as it's reached its life cycle end. An engineer will be able to assist you with this. The fuser unit needs to be replaced as it's reached its life cycle end. The paper pick-up rollers and separation pads have reached their life cycle end and need to be replaced to avoid paper jams. Try switching the printer off and on or seek a replacement fan if the problem persists. In this instance, switch the printer off and then on again. There has been a malfunction of the main motor which drives all of the printing functions. Turning the print off and on should resolve this. There has been a malfunction of the laser motor with the spinning mirror and motor itself developing a fault. Try switching the printer off and on again. There has been a malfunction of the laser unit and the laser beam is not being detected.
If the problem persists, contact the manufacturer. Switch the machine off for 5 minutes then on again. There has been a malfunction of the fuser unit and the temperature, in particular.
0 kommentar(er)
